Photocell Wiring Diagram - Circuit Diagram

Picture this: you're a homeowner, and you want to install automated outdoor lighting. You know it's going to be a lot easier if you have the right wiring setup, but all you're left with is a confusing photocell wiring diagram.

Fear not: understanding how to wire your photocell is not as intimidating as it may seem. With a little knowledge and a basic understanding of electricity, you can easily get your outdoor lighting up and running in no time.

A photocell is basically a light-sensitive electrical switch. It turns on lights when light levels are low outside and turns them off when light levels rise. In order for it to work properly, the wiring needs to be done correctly. Otherwise, your lights may not be getting the power they need to turn on.

To wire a photocell, you'll need to connect it to your home's existing power supply and lighting system. Generally, you'll need to connect three wires to the photocell before connecting it to the power source and light switch. Connect the black wire to the "hot" side of the power supply or the line side. Then, connect the white wire to the neutral side. Finally, the red wire should be connected to one side of your light switch.

Depending on your lighting system setup, you may also need to wire your photocell to an additional ground wire. This is generally optional, but it's important to make sure your wiring is up to code so that your lighting system will be safe and secure.

Once your photocell has been securely wired, you should be able to control your outdoor lighting directly from the switch, allowing you to turn it on and off remotely. Installing your own outdoor lighting with a photocell wiring diagram shouldn't have to be intimidating; with a few simple steps, you can have a reliable system running in no time.

Tork 2001 Thermal Photocell Spec Sheet